Replace Print head and logic board (Replace them at the same time.).Turn off the printer and then turn on if error still persist replace Ink cartridge or print headĬondition: A problem occurred in reading from or writing to the EEPROM.Ĭondition: The print head voltage is abnormal.Print head temperature rise error or Error Code 5200Ĭondition: The print head temperature exceeded the specified value.
Replace printer's Ink absorber pad and reset the ink absorber counter value in the EEPROM.Ĭlick here for your printer model reset procedure and service tools
Ink absorber is full or waste pad inside the printer is almost full.Message on the Monitor screen or printer LCD: Ink absorber full. Ink absorber is full or Error Code 5B00, 5B01Ĭondition: The ink absorber is supposed to be full. Internal temperature error or Error Code 5400Ĭondition: The internal temperature is not normal. Foreign material or paper debris around the purge drive system unit Ĭondition: An error occurred in the ASF cam sensor.Purge cam sensor error or Error Code 5C00Ĭondition: An error occurred in the purge unit. Foreign material or paper debris in the LF drive.Smearing or scratches on the LF / EJ slit film.If other solution fail, replace one off the followingĬondition: An error occurred in the LF encoder signal.Foreign material or paper debris that obstructs the carriage movement.
Smearing or scratches on the carriage slit film.Pressing the Resume/Cancel button will exit theġ4 times Non-supported ink cartridge installed Replace the non-supported ink cartridge with theġ6 times Used ink cartridge installed, or no ink Pressing the Resume/Cancel button will exit the error, and enable printing.Ĭondition: An error occurred in the carriage encoder signal. Or, confirm that the supported ink cartridges areħ times Ink cartridge not installed Install the ink cartridge(s), and close the access cover.Ĩ times Waste ink absorber full or platen waste ink absorber full warning (approx. (the ink cartridge EEPROM data is abnormal). Operator Call Error (Alarm LED Blinking in Orange)Ģ times No paper Set paper, and press the Resume/Cancel button to feed the paper.ģ times Paper jam Remove the jammed paper, and press the Resume/Cancel button.Ĥ times No ink Replace the ink cartridge(s), or press the Resume/Cancel button to continue printingĥ times The ink cartridges are not properly installed, or a non-supported ink cartridge is installed Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.ģ-1.
0 kommentar(er)
